The so-called pipeline tracer wire can be understood in this way, and it is a kind of signal cable that assists in the future maintenance and positioning of buried non-metallic pipelines. Here are some supplements to the construction precautions of the tracer wire, which are briefly introduced as follows:

1, When using, pay attention to the setting out length of the trace line, and pay as much as you use it. Do not pour out all the trace lines at one time.

2, When the tracer wire enters the directional drilling hole with the pipe, someone should watch over it to avoid knotting or entanglement of the tracer wire.

3, It is suggested to have a simple paying off frame, which can fix the tracer wire on the paying off frame, so that the tracer wire and the pipe can be dragged at the same time.

4, During pipe dragging, the trace line shall not be tripped by small trees or other obstacles to avoid being pulled off.

5, The tracer wire and the top of the pipe shall be tied firmly to prevent the tracer wire from falling off when the pipe is crossing. If the trace line is to be above the ground surface, a certain length shall be reserved appropriately. It is suggested that the reserved length of the trace line after leaving the ground should be about 1.5m for detection.

6, The tracer wire shall not have joints during the use of directional drilling.

In addition, after the pipe laying is completed, the pipeline detector shall be used to test the detectability of the laid tracers to ensure that the metal wires have been connected properly, and the test results shall be recorded. More relevant precautions come to our website http://webtest2.daoshangbao.cn Consult and understand!